Improve your soldering with photo feedback from Gemini

← All use cases / Learning

ToolGemini

A hobbyist practising soldering for a DIY drone build takes photos of their work and asks Gemini to critique it. The feedback taught them things about soldering iron tips they hadn't realised, and switching from a broad knife tip to a chisel tip made their joints much better, though they stress that hours of practice can't be replaced by reading.

Prompt to copy
I'm learning to solder for [PROJECT, E.G. A DRONE / A GUITAR PEDAL / REPAIRS]. Here's a close-up photo of some joints I've just made. I'm using [IRON AND TIP TYPE, E.G. A 60W IRON WITH A CONICAL TIP], [SOLDER TYPE] at about [TEMPERATURE]. Look at each joint and tell me whether it looks good, cold, dry, bridged or has too much or too little solder, and what probably caused it. Then give me the two changes most likely to improve my next attempt, such as technique, temperature or tip choice.

Replace the [PLACEHOLDERS] with your own details before you send it.

How to try it

  1. Make a few practice joints on a spare board or old electronics before you work on the real project.
  2. Take a sharp, well-lit close-up photo of the joints from more than one angle.
  3. Send the photo to Gemini with details of your iron, tip, solder and temperature, and ask for a joint-by-joint critique.
  4. Change one thing at a time based on the feedback, such as the tip shape or how long you hold the iron, then solder and photograph again.
  5. Keep the photos in order so you can see your progress from week to week.

Why this works

Soldering is a hands-on skill, and the hardest part for beginners is knowing what a good joint looks like and why a bad one went wrong. Videos show the ideal, but they can’t look at your joints. Photo feedback closes that gap: you get a second pair of eyes on your actual work and a likely cause for each problem. That steady loop of practise, check and adjust is the core of our guide to learning a new skill in 30 days with AI.

Tips to get a better result

  • Mention the tip shape you’re using; as this hobbyist found, the right tip for the job can make a big difference.
  • Ask for the reason behind each fault, not just a label, so you learn what to change.
  • Compare the feedback with a reputable soldering guide or video, especially for anything to do with heat and safety.
  • Planning a bigger build? Our guide to making a DIY project shopping list with AI helps you gather the right parts first.

Common mistakes

  • Expecting the AI to replace practice; it can point out problems, but only time with the iron fixes them.
  • Sending blurry or dark photos, which make it impossible to judge a joint properly.
  • Skipping basic safety: work somewhere ventilated, use a stand for the hot iron and wash your hands afterwards, especially with leaded solder.

Try a variation

Here’s a variation of our own to try next:

Set me a two-week soldering practice plan for a complete beginner, with one short exercise a day, such as tinning wires, through-hole joints and joining two wires, and tell me what a good result should look like in a photo for each one.

Related

Read the full guide →

More learning use cases

Make verb charts to help your child learn a language with Claude

A parent who doesn't speak Romanian used Claude to make verb charts and pages for their son, explaining each tense in English first. The polished first drafts didn't sink in, so they went through sentence by sentence, making Claude rewrite anything unclear until the ideas were easy to follow.

Full guide →
Source: Hacker News

Turn your ‘read later’ pile into a short audio summary with NotebookLM

An XDA writer fed NotebookLM the links from about 30 old 'read later' bookmarks and generated an Audio Overview. The 15-minute discussion pulled out the key ideas and showed which three articles were worth reading properly.

Source: XDA

Reference: Hacker News